Used reference standard

NRX Absorption RF Power Meter Mainframe

• Manufacturer: 德国罗德与施瓦茨/R&S

Introduction: The NRX can be configured with up to four measurement channels and a wide range of power sensors, making it possible for a single power meter to support both absorption and through-type power sensor...

NRT through-type power meter

• Manufacturer: 德国罗德与施瓦茨/R&S

Introduction: Reflection power meter with a frequency range of 200kHz to 4GHz; no attenuator is required, and the maximum measured power can reach 2000W; it displays the measured power and reflection simultaneous...

Datum PRFS-202 1, 5, 10 MHz Rubidium Frequency Standard..$550.

Datum PRFS-202 1, 5, 10 MHz Rubidium Frequency Standard..$550.

3561 Battery Tester

• Manufacturer: 德国罗德与施瓦茨/R&S

Introduction: The inspection range covers large battery cells to high-voltage battery packs, and the internal impedance and battery voltage can be measured at high speed. A maximum of 30,000 data can be counted, ...

JDSU OMK7

• Manufacturer: JDSU - Viavi - Acterna

JDSU OMK7 Details JDSU OMK7 The JDSU OMK-7 is a handy, pocket-sized instruments optimized for absolute power and loss measurements. This Kit also includes one power meter and one light source as standard. This co...

Kikusui TOS8750

• Manufacturer: Kikusui

Kikusui TOS8750 Details Kikusui TOS8750 5 kV AC/DC, Withstanding Voltage Tester Features: -Voltage Range:0- 5kV AC/DC -Output Waveform: AC (Line Voltage)/DC -Applied Voltage Ranges: 0~1.5/0~5kV -Current: AC: 100...

Rohde & Schwarz ESVS-30

• Manufacturer: Rohde & Schwarz
• Model: ESVS

Form Factor Benchtop Test Standard(s) ANSI,C63.4,EN,CISPR,VDE0876 Minimum Frequency 20 MHz Maximum Frequency 1 GHz Input Impedance 50 Ohm Frequency Accuracy 0.000000000000003 % Minimum Sweep Time 50 ms Ma...

Calibration of Rogowski type probes up to 6000A

• Manufacturer: ANMAR Polska Sp z o.o

The 52120A / COIL3KA, COIL3000 A and COIL6KA are 12-volt coils, with a maximum voltage rating of 4.5 V RMS. With forced convection cooling, it can operate continuously at 120 amperes, allowing calibration of clam...

GNGPL-UL498 Plugs and Socket Outlets Gauges for UL 498 of American Standard

• Manufacturer: Lisun

Application: This plug and socket test gauge is mainly used to test and inspect whether the structure and size of plugs and sockets conform to UL 498:2012 standards. And the mainly application industries is elect...

Schaffner CDN8014

• Manufacturer: Teseq - Schaffner

no options The Teseq (Schaffner) coupling clamp is primarily used to inject fast transient and burst interference pulses into signal and data cables, i.e. into any type of connection to peripheral equipment. The ...

From the column:

From the category: HF voltmeter / powermeter Now also available as URY incl. option B2 Rohde & Schwarz URV 5 The URV 5 from Rohde & Schwarz is a broadband, sensitive, 2-channel RF voltage, level and power meter. ...

Agilent 8481A Power Sensor

• Manufacturer: Agilent

• Excellent SWR for reducing mismatch uncertainty • Accurate calibration and traceability to US National Institute of Standards and Technology (NIST) • Compatible with EPM, EPM-P and P-series power meters, plus t...

GF302C portable panel power meter calibrator

This device is according to nation verification regulation JJG124-2005 "ammeter, voltmeter, power meter and resistance meter calibration regulations and the relevant countries standard requirements and design thr...

SUG-CCITT-A Impulse Test Generator

Impulse Test Generator SUG-CCITT-A (Circuit 1, 10/700μS, according to Figure D.1/ Table D.1 in IEC 62368-1:2018 Annex D, Figure K.1/ Tabke K.1 in IEC 60065:2014 Annex K , and Figure N.1/ Table N.1 in IEC 60950-1:...

MH600 - POWER METER RF - ORITEL - CONTROLLER / 100KHZ - 50 GHZ

RF POWER METERCONTROLLER / 100KHZ - 50 GHZ Measurement range (depending on the probe used): 100 kHz to 50 GHz, -70 dBm to +44 dBm, 100 pW to 25 W Units of measurement Watt, dBm or dB and % in relation to a power ...