Used Processing in Hiroshima, Japan

1990 Plate heat exchanger
- Manufacturer: Hisaka Seisakusho
Where to use: Chemical factory Food factory Environmental recycling factory Water treatment plant | Heat transfer area: 75m2 SUS pressure leak tested, as-is
Kure, Japan
1989 Hisaka Model UX-016-J-36
- Manufacturer: Hisaka
Heat transfer area: 3m2 Design pressure: 5kgf / c㎡
Kure, Japan
SM30D type made by Kanto Blender
- Manufacturer: Made by Kanto Blender
Touchscreen type. Operation confirmed. Note: There is no misalignment of the touchscreen, but there is some white blurring on the panel. This does not affect use. Visibility may be poor.
Kure, Japan
Hokos NP-20D special model
- Manufacturer: Made by hocos
Pulse jet type Filtration area: investigating | Electric motor: 0.75KW 200V 50HZ | Material: Made in SUS
Kure, Japan
2006 GL receiver
- Manufacturer: Made of Ikebukuro enamel
Total volume: 2000L Design pressure: 0.3MPaG Design temperature: About 50 ℃ No repair history.
Kure, Japan
Hot air dryer (current dryer)
- Manufacturer: Made by Tsutsuyoshi
With blower, feeder and operation panel With electric circuit diagram Application (Drying of powder, granule, etc.) Confirmed that the main operation panel is energized.
Kure, Japan
Liquid agitator
Material: Made of SUS Total volume: 500L With stirring device For liquids Detailed investigation
Kure, Japan
2004 Kajiwara Model KQ-2
- Manufacturer: Made by Kajiwara
Total capacity: 200L, Capacity: 120L, Made of SUS Manual overturn type, hot water heating type (with built-in electric heater) Operation checked, cleaned and painted
Kure, Japan
Dual-armed kneader
- Manufacturer: Mitsui mine
Total capacity: 200L Actual capacity: 120L Banbury type Electric Rollover Type with Jacketed Top Lid
Kure, Japan
1991 Hammer mill
- Manufacturer: Made by Buehler
Where to use: Chemical factory Feed and fertilizer factory Environmental recycling factory | Main power: 75KW 200V Maintained Swing hammer screen 1mm Feed grinder Main body only
Kure, Japan
Fuji Electric VCS702A
- Manufacturer: Fuji Electric
High pressure type turbo blower Air volume: 13m3/min Static pressure: 14.0kpa Disassembled, cleaned, assembled, and operation checked For details, please refer to the specification catalog.
Kure, Japan
2012 Hitachi OSP-22S6ARN-7K
- Manufacturer: Hitachi
Oil-cooled screw compressor Pressure: 0.85MPa Operating time: 6400h
Kure, Japan
Mitsui Seiki U-140226A-R type
- Manufacturer: Mitsui Seiki
Where to use: Chemical plant Food plant Feed and fertilizer plant Environmental recycling plant Crushed stone plant Water treatment plant | Package type power supply: 200V 60HZ | Max. working pressure]0.7 mpa po...
Kure, Japan
2006 Receiver tank
- Manufacturer: KOBELCO (Kobe Steel, Ltd.)
With safety valve Main unit only Where to use: Chemical plant Food plant Feed and fertilizer plant Environmental recycling plant Crushed stone plant Water treatment plant | Capacity: 1,000L Iron 800φ×2,000H | Pre...
Kure, Japan
1980 Hosokawa Micron Model NX-35
- Manufacturer: Hosokawa
Conical Mixer NX-3500 Stainless steel inside (white is dust) Pin joint fixed Air cylinder discharge type White inside is lime dust Currently cleaned
Kure, Japan