Used Processing in British Columbia, Canada

HYDRO-O FLEX TRAILER DUMP

- Built in 1994 - Back on style - 65' long deck x 10" wide - 50 ton capacity - 63 degree tilt angle - Two (2) hydraulic cylinders (chrome plated) - Hydraulic Power Unit (575/3/60) - Hopper c/w twelve (12) strand ...

16' CanCar Half Taper Infeed

• Manufacturer: Canadian Mill Equipment

- Alligator chain - 2 infeed spike rolls c/w 5 HP motors - Infeed drive complete - Good condition - New spare top & bottom chain

CanCar Side Head Module

• Manufacturer: CanCar

- Side head module - 3 knife segments - 2 Coleman inserted outfeed rolls - 5 HP - No motors

ALLIED #40 Material Fan with 30 HP

• Manufacturer: Allied

-mounted on stand - 30 HP - still installed

Large Blower

- Shroud is 102" diameter x 28" wide - Fan is 61" diameter x 20" wide - Was run by a 150 HP motor (not included) - Needs paint job but mechanically sound - Located on West Coast of BC - Ready to load

Chicago Boiler Air Dryer

• Manufacturer: Chicago Boiler

- Two (2) air tanks - 31" diameter x 6'-4" long tank - 7.5 HP, 230/460 volt, 1750 RPM - Maximum psi - 150 @ 500 OF - Tank serial #807442-1 & 807442-2 - Built in 1980 - Some piping

STEP FEEDER

- Double acting step feeder - Six (6) steps approximately 10 feet long - No end walls - Electrically driven (drive not included) - Disassembled

36" x 48" Falcon Rotary Hog

• Manufacturer: Falcon RME

- Built in 1992 by Clarkes - Drop feed - 36" x 48" Rotary Hog c/w fixed hammers - Two (2) 8V-8 groove sheaves on rotor - No motors included (originally driven by two (2) 250 HP motors) - Cylinder operated hinged ...

20' x 60' Roof Top Pull Chains (2 only)

• Manufacturer: Canadian Mill Equipment

- Five (5) runs of roof top chain c/w rollers on side - Approximately 50' long - Electric motor/reducer drive unit - Still installed

15' Double Screw Conveyor

- 15' x 36" wide - Dodge gear box - Motor removed

8" x 35' Screw Conveyor

- No drive

12" x 16' Belt Conveyor

- Fabricated steel trough 13" wide x 9" deep - Belt - Head and tail pulley - 5 HP electric drive

30" Troughing Conveyors - Bridge Type

- Approximately 7' wide x 7' high c/w catwalks - One (1) section 96' long - One (1) section 126' long - 30" wide troughing rolls (approx. 3'-9" c/c) - No drives - No head and tail pulleys

36" Conveyor

- Truss type - Covered with catwalk - c/w two (2) sets of drives & belt - 40'-0" sections - 500" feet available

36" x 45' Troughing Roll Conveyor

- Channel frame construction - Approx. 45' long (two sections) - 25 HP drive assembly (no motor) c/w head pulley - Tail pulley - Belt