Used Ball Mills in New Jersey, USA

Ball Mill Approximately 30"x30" Chamber

used Ball Mill. Approximately 30"x 30" Chamber. Ceramic Lined. On stand with 2 HP, 3ph, 60 cyc, 1750 rpm motor.

Carbon Steel Ball Mill - IPP# 97152

conical ball mill Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm. belt driven by motor via bull gear

Ball Mill Carbon Steel - IPP# 97153

• Manufacturer: Hardinge

conical balls. Belt driven by motor via bull gear. Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.

Ball Mill Carbon Steel - IPP# 79105

• Manufacturer: Blaw Knox

CS/Ni-hard lined 650 deg F. 2"-6" CS ball charge Gear driven by 40 HP, 3/60/220/440 volt thru Falk gear reducer, ratio 32.69:1. Bull and pinion gear ratio 4.85:1. Unit has Manzel fully centralized lubrication sys...

Ball Mill Carbon Steel - IPP# 79104

• Manufacturer: Blaw Knox

650 deg F. 2"-6" CS ball charge Gear driven by 40 HP, 3/60/220/440 volt, Phila gear reducer ratio 30.6:1. Bull and pinion gear ratio 4.85:1. Unit has Manzel fully centralized lubrication system w/6-station Manzel...

Ball Mill Carbon Steel - IPP# 97154

• Manufacturer: Hardinge

conical ball belt driven by motor via bull gear Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.

Ball Mill TEMA Siebtechnik ESM 234-1 BS Stainless Steel 316 - IPP# 212441

• Manufacturer: Siebtechnik

Eccentric vibrating mill Type ESM Ball Mill Usable volumn is 5 liter maximum Total grinding tube volume is 19 liters, grinding medea volume is 15 liters 235 mm ID x 450 mm L. Unit is batch design, suitable for we...

Ball Mill 1.59 m3 (56 ft3) Stainless Steel 304 - IPP# 218254

with CS heat box Cylindrical Rod Mill, with LP gas fired heating system Feed line input(liquid) 1.5" diameter pipe. Discharge port is 8" round with a 8.8" x 32" vent Drive is by a Lincoln AC motor, Model BVJ AAF4...

Ball Mill 0.1 m3 (3.5 ft3) Stainless Steel 304 - IPP# 209723

• Manufacturer: Engineering Plastics

Plastic Lined Pilot Plant Ball mill / bead mill Water jacket on the outside of the shell, the inside of the grinding chamber is completely lined with hard plastic coating. will hold 170 kilograms of beads(media n...