Used Processing in France

Pilger Mill LP4

• Manufacturer: DMS MONTBARD

DMS MONTBARD Cold Pilger Mill, LP4 (1971) Crankshaft/engine reduction ratio: 0.25 *Reducer requires maintenance This lot is part of a combination lot: 20 Cold Pilger Mills Not the machine you are looking for? Sen...

Pilger Mill 4" 1/2, N°1

• Manufacturer: Mannesmann Demag - Meer

MANESMANN MEER Cold Pilger Mill, 4" 1/2, No.1 (1969) Crankshaft/engine reduction ratio: 0.18 This lot is part of a combination lot: 20 Cold Pilger Mills Not the machine you are looking for? Send us your requirements

Pilger Mill 4" 1/2, N°2

• Manufacturer: Mannesmann Demag - Meer

MANESMANN MEER Cold Pilger Mill, 4" 1/2, No.2 (2003) Crankshaft/engine reduction ratio: 0.18 This lot is part of a combination lot: 20 Cold Pilger Mills Not the machine you are looking for? Send us your requirements

Hot Sampling Saw and testing unit

Hot Saw to cut tubes sections for sampling Capabilities: Associated Equipment: – Sample elevator (transfer) to testing pulpit at elevated floor – VOLLMER excentricity testing equipment for samples cut after Rotar...

LIMAB measurement after Rotary Sizer Mill

• Manufacturer: LIMAB

Performs continuous measurement of tube geometry immediately after the rotary sizer stage. This lot is part of a combination lot: 10 Hot Rolling Mill Not the machine you are looking for? Send us your requirements

14-Stands Calibration Mill (Calibreur)

• Manufacturer: DMS MONTBARD

Capacity: Associated Equipment: – 90 bar pump high-pressure descaling system before first stand – Guiding system for tube alignment into the rolling stands – Stands’ maintenance related equipment Motor & Drive: –...

ZUMBACH Laser Measurement after Elongation Mill

• Manufacturer: Zumbach

Function: – Continuous, non‑contact measurement of tube outside diameter (OD) and ovality using laser beam Position: – Immediately after the elongation mill, before calibration and sizing Capability: SCHNEIDER PL...

Billet Cutting Station

• Manufacturer: CENTROCUT

Fully automated billet cutting line including: (2) Saw Cutting Machines, individual 462 W motors, common (shared) hydraulic unit, Inlet conveyors, Outlet conveyors, scrap conveyors,control system,80 to 240 mm bil...

Hot Rolling Mill

Hot Rolling Mill Equipment Combination Lot of the following: Lot No. 1100Hot Sampling Saw and testing unitLot No. 1110Hot Tubes Cooling BedLot No. 107014-Stands Calibration Mill (Calibreur)Lot No. 1080Rotary Size...

Central Workshop

• Manufacturer: Cutler-Hammer

Maintenance, tooling, and fabrication support for tube production and finishing lines. Enables in‑house repair, adjustment, and preparation of mechanical components, cutting tools, and fixtures. Combination Lot o...

Viscosity tester JULABO

• Manufacturer: Julabo

Viscosity tester JULABO This lot is part of a combination lot: 70 Laboratory Not the machine you are looking for? Send us your requirements