Used packaging in Ohio, USA

10" Three Roll Sheet Stack

• Manufacturer: Randcastle

10" Three Roll Sheet Stack Used 10" three roll vertical sheet stack, approximately 10" wide x 6" diameter rolls, chromed top and bottom rolls, textured middle roll, silent chain drive with 1 hp dc motor, integrat...

Entrex Gear Pump, Model 70-4 ST

• Manufacturer: Entrex

Entrex Gear Pump, Model 70-4 ST Used Entrex gear pump, model 70-4 ST, order# 50042135-10-2, built 2001.

CIP Skid

CIP Skid CIP Skid, with stainless steel tank, on skid with 5 hp Waukesha model 060 circulation pump, 3 phase, 230/460 volts, with (2) diaphragm pumps on skid.

12" NRM Three Roll Sheet Stack

• Manufacturer: NRM

12" NRM Three Roll Sheet Stack Used 12" NRM three roll vertical sheet stack, chromed and cored rolls with rotary unions, manually adjusted top roll, integrated pull roll assembly with adjustable top rubber roll, ...

Niro Fielder NICA S-450 Spheronizer, S/S

• Manufacturer: Niro Fielder

Niro Fielder NICA S-450 Spheronizer, S/S Used Niro Fielder NICA spheronizer, model S-450, stainless steel construction, 450mm diameter bowl, nominally rated .4-2 kg batch size, approximately 1.5 kw variable speed...

Lantech SW-1000 Intermittent Motion Belt Feed Side Seal Wrapper w/ Lantech ST-900 Heat Tunnel

• Manufacturer: Lantech

Units is USED. Some minor scratching/blemishes/scraps/small dents can be seen on the surfaces of the unit, but is not affecting the unit intended use. The unit was removed a working environment and was functionin...

Caleva Spheronizer, Model 500

• Manufacturer: Caleva

Caleva Spheronizer, Model 500 Used Caleva spheronizer, model 500, rated up to 60 kg/hr.

34" Cincinnati Milacron Two Roll Sheet Stack

• Manufacturer: Cincinnati

34" Cincinnati Milacron Two Roll Sheet Stack Used 34" Cincinnati Milacron two roll sheet stack, 18" diameter x 34" roll face width rolls, vertical stack orientation, chromed and cored rolls with rotary unions, si...

Niro/Aeromatic Spheronizer Disk, Model S320

• Manufacturer: Niro Aeromatic

Niro/Aeromatic Spheronizer Disk, Model S320 Used Niro/Aeromatic spheronizer disk, model S320, stainless steel.

Aeromatic Spheronizer, Model S-320

• Manufacturer: Niro Aeromatic

Aeromatic Spheronizer, Model S-320 Used Aeromatic Nica Spheronizer, model S320, stainless steel construction, 2 kg capacity, 0-1000 rpm, 12.5" diameter x 5.5" deep bowl, 1.5" x 1.5" side flush type slide gate val...

24" Wide Uncoiling Stand

24" Wide Uncoiling Stand Used pipe uncoiling stand, approx. 24" wide x 16" diameter hub, approx. 78" diameter coil take up.

24" Payoff Stand

24" Payoff Stand Used payoff stand, 1.25" shaft, 24" wide, capable of up to 30" diameter reel with brake, 120V

4" x 8" Ross Three Roll Mill

• Manufacturer: Ross

4" x 8" Ross Three Roll Mill Used Ross three roll mill, model 4X8TRM, 4" diameter x 8" roll faced width cored rolls, end guide holders less end guides, adjustable first and third rolls, knife apron discharge, app...

14" x 30" Day Three Roll Mill

• Manufacturer: DAY

14" x 30" Day Three Roll Mill Used 14" X 30" Day Three Roll Mill, 14" diameter X 30" long rolls, cored rolls, manually adjusted first and third rolls, knife discharge, end guides for first and second rolls, with ...

10" x 102" Twin Screw Feeder, S/S

10" x 102" Twin Screw Feeder, S/S Used 10" Twin screw feeder, stainless steel construction, with (2) 5" diameter x 102" long inter-meshing co-rotating screws, 10" wide trough, 1.5" screw pitch, 6" x 9" feed openi...