Used processing in British Columbia, Canada

ANDRITZ Pulp Flash Drying System w/ 1 x Fluffer

• Manufacturer: Andritz

Flash Drying Line - Process Control Diagrams Includes: 1 x ANDRITZ HCM2 Fluffer Flash Drying Air Tanks Flash Dryer Heating Element All Fans, Motors and Control Panels

1987 ANDRITZ Pulp Flash Drying System w/ 2 x Fluffers

• Manufacturer: Andritz

Flash Drying Line - Process Control Diagrams Includes: 2 x ANDRITZ HCM2 Fluffer Flash Drying Air Tanks Flash Dryer Heating Element All Fans, Motors and Control Panels

SUNDS DEFIBRATOR RGP 70/76 CD

• Manufacturer: SUNDS

20' Hemco Trimmer

• Manufacturer: Hemco

- Board dealer c/w 6 strand 81X, motor & drive - good condition - Trimmer - Left hand, 11 saws, 22" diameter carbide, 7 HP on "0" saw, 5 HP on all others, 11 cylinders, 9 air actuators. Will pass 24 ft board. Inf...

30' Rollcase (Approx.)

• Manufacturer: Canadian Mill Equipment

- Nine (9) 8" diameter x 26" face bedrolls c/w double single chain drive mounted onto a channel frame - No drive unit

Optimil Double Length Infeed - Side Shift and Skew

• Manufacturer: Optimil

- Built in 1999 - 4" to 20" diameter (was set up for 14" diameter) - 8' to 20' length - Base feed speed 300 FPM @ 60 hz - Main frame supported on two (2) roundway slides c/w linear positioners - Twelve (12) holdd...

Comact DDM10 Line

• Manufacturer: Comact

- 10 years old - Approx. 120' V-flite conveyor including drive and attached control devices - Flying log turner - new HD upgrade 2011-12? (Quad roll) - DDM10 full profile machine, 480 volt - All drive units, moto...

20' Rollcase (Approx.)

• Manufacturer: Canadian Mill Equipment

- Seven (7) 8" diameter x 34" face bedrolls c/w double single chain drive mounted onto a channel frame - No drive unit

CanCar Side Head Module

• Manufacturer: CanCar

- Side head module - 3 knife segments - 2 Coleman inserted outfeed rolls - 5 HP - No motors

2017 GL&V BOWSCREEN TS3

• Manufacturer: GL&V

PDF TECHNICAL DRAWINGS PDF INSTRUCTION MANUAL Principle of Operation: The decker consists of a wire mesh covered cylinder (mould) rotating in a vat of stock. Level differences between the inside and outside of th...