Used processing in New Jersey, USA

Ball Mill Carbon Steel - IPP# 79105

• Manufacturer: Blaw Knox

CS/Ni-hard lined 650 deg F. 2"-6" CS ball charge Gear driven by 40 HP, 3/60/220/440 volt thru Falk gear reducer, ratio 32.69:1. Bull and pinion gear ratio 4.85:1. Unit has Manzel fully centralized lubrication sys...

Ball Mill Carbon Steel - IPP# 97153

• Manufacturer: Hardinge

conical balls. Belt driven by motor via bull gear. Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.

Ball Mill Carbon Steel - IPP# 79104

• Manufacturer: Blaw Knox

650 deg F. 2"-6" CS ball charge Gear driven by 40 HP, 3/60/220/440 volt, Phila gear reducer ratio 30.6:1. Bull and pinion gear ratio 4.85:1. Unit has Manzel fully centralized lubrication system w/6-station Manzel...

Stainless Steel 316 TEMA Siebtechnik ESM 234-1 BS Ball Mill - IPP# 212441

• Manufacturer: Siebtechnik

Eccentric vibrating mill Type ESM Ball Mill Usable volumn is 5 liter maximum Total grinding tube volume is 19 liters, grinding medea volume is 15 liters 235 mm ID x 450 mm L. Unit is batch design, suitable for we...

Ball Mill 0.1 m3 (3.5 ft3) Stainless Steel 304 - IPP# 209723

• Manufacturer: Engineering Plastics

Plastic Lined Pilot Plant Ball mill / bead mill Water jacket on the outside of the shell, the inside of the grinding chamber is completely lined with hard plastic coating. will hold 170 kilograms of beads(media n...

Ball Mill Carbon Steel - IPP# 97154

• Manufacturer: Hardinge

conical ball belt driven by motor via bull gear Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.

Ball Mill Carbon Steel - IPP# 97155

• Manufacturer: Hardinge

conical ball belt driven by motor via bull gear Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.

Carbon Steel Ball Mill - IPP# 97152

conical ball mill Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm. belt driven by motor via bull gear

Ball Mill 1.59 m3 (56 ft3) Stainless Steel 304 - IPP# 218254

with CS heat box Cylindrical Rod Mill, with LP gas fired heating system Feed line input(liquid) 1.5" diameter pipe. Discharge port is 8" round with a 8.8" x 32" vent Drive is by a Lincoln AC motor, Model BVJ AAF4...

Ball Mill Approximately 30"x30" Chamber

used Ball Mill. Approximately 30"x 30" Chamber. Ceramic Lined. On stand with 2 HP, 3ph, 60 cyc, 1750 rpm motor.