Metso Lokotrack LT1213S Unit #1156 in Eau Claire, WI, USA

1st grizzly – Grizzly spacing 52 mm (2")
Upper grizzly
2nd grizzly – ZigZag 38 mm (1½")
Lower grizzly
Screen deck media – Steel cloth 35 mm (1 3/8")
Screen media to separate fines from feed and guide them to side conveyor.
Screen mesh is mounted under the grizzlies.
Feed hopper – Extended 9 m³ (12 yd³)
Side walls are folded down for the transport. Feed hopper side walls are hydraulic operated and locked.
No tools required for set up.
Increases the volume of the standard feed hopper.
Enables the loading of the Lokotrack LT1213S either with an excavator or wheel loader and is made of wear resistant steel.
Side conveyor – Included (H5-4)
Belt conveyor for transporting the fine material to the side of the Lokotrack.
The side conveyor is equipped with hydraulic drive and stop buttons both sides of the conveyor.
The folding and lengthening of side conveyor is hydraulic.
Crusher
Crusher - NP1213M impact crusher
Part of the NP series horizontal shaft impact crusher range.
This range features a unique combination of heavy rotor design, wear material and crushing chamber design.
The design minimizes maintenance time and improves all adjustment operations.
NP series impact crushers deliver unbeatable performance in primary, and recycling applications.
Hammers – Xwin Recyx Blue
Setting adjustment – Hydraulic assistance
Single acting cylinder relieves the setting nuts from the breaker plates weight and allow the operator to screw or unscrew easily.
A hydraulic power unit is used to open the frame and assist the breaker plate setting.
Service hoist – Included
Lifting device for changing the crusher wear parts.
Transported separately in one piece.
Power Unit
Diesel engine – CAT C9.3B
Emission class – Tier 4F
Tier 4 Final (stage IV) emission regulated engine
Climate kit – Standard (-20C/-4F...35C/95F)
Main Conveyor
Main conveyor – Standard with pan feeder
Belt conveyor for transporting the crushed material from the crusher to the discharge point.
The conveyor is equipped with discharge hood, hydraulic drive and emergency stop wires on both sides of the conveyor.
Magnetic separator – preparation
Permanent magnet to remove the iron waste form the crushed material.
Provision for the mounting of a magnetic separator above the main conveyor
Screening Unit
Screening unit – Included
Horizontal single deck, single shaft screen.
Steel wire and rubber screen clothes available.
Screen module DS16-36 with H12-7 conveyor
Screen media – steel cloth 40 mm (1 37/64”)
Optional Equipment
Interlocking – Included
Secondary unit material level will control the feeding of primary unit.
Hydraulic power take off – Included
For connecting the auxiliary hydraulic equipment to the hydraulic system of the Lokotrack.
Water spraying system – Included
For binding dust particles at the crusher cavity, under the crusher and at the discharge end of main conveyor.
Remote radio control – Included (US / 458Mhz)
Enables the remote control of following functions: start/stop of feeder unit, rpm adjustment of diesel engine, moving forward/reverse (tracks).
Cable controller is always supplied with Lokotrack.
Metso metrics system – Included
Remote monitoring and reporting system for Lokotrack.
Consists of modem and antenna installation.
Access to the monitoring and maintenance scheduling system and reporting services can be ordered with a separate service contract.
Finishing
Color – Metso beige
Safety labels – ANSI
Display unit language – English
Documentation
Quantity of printed manuals – 2
Electronic spare part book – Included
Quantity of spare part books – 2