Used Extruders

Trusted Seller
RANDCASTLE Ø51 мм × 203 мм
- Manufacturer: RANDCASTLE
Used 2" O.D. x 8" Wide Randcastle Sheet Extrusion 3-Roll Stack including Pull Roll Station and Single Position Winder.
Hainesport, NJ
Trusted Seller
BUSS 200 HP
- Manufacturer: Buss
Used 100mm Buss kneader with 9/1 L/D barrel. Driven by 200 hp DC motor, includes 5.94/1 gearbox, jacketed barrel and clam shell barrel opening. Includes operator control panel. Kneader will discharge into approxi...
Hainesport, NJ
Trusted Seller
Conair D400H
- Manufacturer: Conair
- Model: D400H
Used Conair model D400H high heat desiccant dryer, 300 cfm. Have carousel desiccant cartridges, operator controls, no hopper. Previously used with 900-1000 lb hopper.
Hainesport, NJ
Trusted Seller
THORESON MCCOSH TD2000
- Manufacturer: Thoreson McCosh
Used 6,000 lb. Thoreson McCosh Desiccant Dryer Model TD2000. Serial #201-703-05. 480 volt, AC input, 20 hp. Amps 236.0, kw 182.0. No hopper included.
Hainesport, NJ
Trusted Seller
UNA-DYN GS150
- Manufacturer: Una-Dyn
Used Una Dyn Piovan Desiccant Dryer. Model GS150, serial #237240-01-01-0903. Rated at 150 cfm. Includes approximately 800 LB., 30" diameter x 72" straight side x 19" cone bottom insulated hopper with top mounted ...
Hainesport, NJ
Trusted Seller
Motan 100
- Manufacturer: Motan
Used 300 lb. Motan model 100 desiccant dryer. No hopper included. Serial #9003860. 6 kW total heater load, 80-100 psi air, 2.3 HP. 240 volt AC input.
Hainesport, NJ
Trusted Seller
THORESON MCCOSH TD360
- Manufacturer: Thoreson McCosh
Used Thoreson McCosh Model TD360 desiccant dryer including approximately 1000 lb. hopper. Rated at approximately 360 lbs. per hour. Includes 10 hp 460 volt motor, Serial #971128.
Hainesport, NJ
Trusted Seller
THORESON MCCOSH TD-24
- Manufacturer: Thoreson McCosh
Used Thoreson McCosh Model TD-24 dehumidifying hopper dryer. Serial #206-152-10. Caster mounted dryer includes 50 lb. capacity insulated hopper mounted on stand. 24 CFM. 480 volt, 3 phase, 60 cycle operation at 9...
Hainesport, NJ
Trusted Seller
CONAIR 18010902
- Manufacturer: Conair
Used Conair hot air Dryer. Model 18010902, serial #137284. No hopper included.
Hainesport, NJ
Trusted Seller
JOHNSON
- Manufacturer: Johnson
Used Johnson roll pull roll stand Has (2) 54" x 8" diameter rubber covered rolls Rolls are driven by 10 hp DC motor Drive-All 4-speed gearbox Air actuated top pull roll
Hainesport, NJ
Trusted Seller
2003 WERNER & PFLEIDERER ZSK20
- Manufacturer: WP
- Model: ZSK20
Used 20mm Werner & Pfleiderer model ZSK20 co-rotating twin screw extruder. Has 40/1 L/D barrel at 43" centerline height driven through a 3:1 gearbox with a 37-Newton meter torque capacity per screw shaft. Extrude...
Hainesport, NJ
Welex HS 3.0 40D SV Single Screw Extruder | 3" Screw | 40:1 L/D | 1520 RPM | 550 HP VFD Drive | Vented Barrel
- Manufacturer: Welex
54129004 Used Welex HS 3.0 40D SV Single Screw Extruder | 3" Screw | 40:1 L/D | 1520 RPM | 550 HP VFD Drive | Vented Barrel. 1520 RPM max. screw speed. Electric heated, air cooled barrel. Vented barrel. 57" barre...
Belvidere, IL
Trusted Seller
BRABENDER 88
- Manufacturer: Brabender
Used 25mm 24/1 L/D Brabender twin screw extruder package. Has air cooled extruder, temperature control panel, type D10002, prep center with model 088 type 09-25-000 temperature pressure module. Includes 10 HP DC ...
Hainesport, NJ
Theyson TSK 060-44D-EXH 1500 Twin Screw Extruder | 60mm | 55 kW | 44:1 L/D | ATEX Motor
- Manufacturer: TheysohnTheysohn
54072001 Unused Theyson TSK 060-44D-EXH 1500 Twin Screw Extruder | 60mm | 55 kW | 44:1 L/D | ATEX Motor. 44:1 L/D. Maximum screw speed 500 RPM via a gearbox by a 55 Kw (73.75hp)1500 RPM-380volt/50cycle/3Ph Ex-pro...
Belvidere, IL
Trusted Seller
2008 COPERION ZSK-40-MEGA
- Manufacturer: Coperion Waeschle
Used 40mm Coperion Mega 40 co-rotating twin screw extruder. New 2008. No barrels or screws included. Driven by 200 hp AC motor, 1790 rpm, with Powerflight VFD controller. Has 1.155 gear ratio supplying 1200 rpm s...
Hainesport, NJ