Building Filters
Dynatel 2273
- Manufacturer: Dynatel
Cable Fault Locator Cal: Calibration Available | As-is: Unit Sold AS-IS
$2,410 USDFarmingdale, NJKeytek ECAT-E502A
- Manufacturer: Keytek
E502A - Plug-in module to produce the telecommunications surge wave required by IEC 61000-4-5, FCC Part 68 and ITU Rec K.17, K.20, and K.21 (formerly CCITT)
$8,395 USDFarmingdale, NJTektronix HV-CA-554-7^
- Manufacturer: Tektronix
The Model HV-CA-554 is a high-voltage triaxial cable assembly that is terminated on either end with a male high-voltage triaxial connector. Key Features:
$2,058 USDFarmingdale, NJTektronix HV-CA-554-3^
- Manufacturer: Tektronix
The Model HV-CA-554 is a high-voltage triaxial cable assembly that is terminated on either end with a male high-voltage triaxial connector. Electrical characteristics Leakage current: Full continuity: Center to c...
$1,145 USDFarmingdale, NJTektronix HV-CA-554-2^
- Manufacturer: Tektronix
The Model CA-554 is a high-voltage triax cable assembly that is terminated on either end with a male high-voltage triax connector. This cable assembly can be used with the Models 2657A High Power System SourceMet...
$1,071 USDFarmingdale, NJTektronix HV-CA-554-1^
- Manufacturer: Tektronix
The HV-CA-554-1 is a 1m high-voltage Triax Cable terminated on either end with a male high-voltage triax connector. This cable assembly can be used with 8010 high power device test fixture, 2657A high power syste...
$995 USDFarmingdale, NJTektronix 3732-MTC-3^
- Manufacturer: Tektronix
The Model 3732-MTC-1.5 / 3.0 cable is a 78-pin cable assembly is 1.5 m (5 ft.) or 3.0 m (10 ft.) in length and terminated with a male D-sub connector on one end and a female D-sub connector on the other end. 8-pi...
$559 USDFarmingdale, NJTektronix 2651A-KIT-2^
- Manufacturer: Tektronix
The Model 2651A-KIT is a high-current, low-impedance coaxial cable assembly that is used to connect the Model 2651A High Power System SourceMeter Instrument to the Model 8010 High Power Device Test Fixture. It al...
$788 USDFarmingdale, NJTektronix 2651A-KIT-1^
- Manufacturer: Tektronix
The Model 2651A-KIT is a high-current, low-impedance coaxial cable assembly that is used to connect the Model 2651A High Power System SourceMeter Instrument to the Model 8010 High Power Device Test Fixture. It al...
$506 USDFarmingdale, NJTektronix 2600-FIX-TRX^
- Manufacturer: Tektronix
The Keithley Instruments Model 2600-FIX-TRX Grounded Phoenix-to-Triax Cable Adapter is a combination dual triaxial connector and low-noise chassis ground banana-plug connector that provides simple connection path...
$578 USDFarmingdale, NJKeytek CM-IOCD
- Manufacturer: Keytek
Waveforms Designed to couple combination waves of 1.2/50µs open-circuit voltage, 8/20µs short-circuit current Repetition Rate Up to 5 per minute at 4.4kV Data Line Frequency Greater than 100kHz without significan...
$1,397 USDFarmingdale, NJEMCO 3810/2
- Manufacturer: Emco
- Model: 38102
Line Impedance Stabilization Network, 9 kHz to 30 MHz, 2 x 10 A Earth Line Choke Artificial Hand Network Test Type - FCC-15, VDE 0871, VDE 0876, EN55022
$2,410 USDFarmingdale, NJDynatel 4420L
- Manufacturer: Dynatel
Cable Fault Locator and Wand Cal: Calibration Available | As-is: Unit Sold AS-IS
$1,045 USDFarmingdale, NJDynatel 573P
- Manufacturer: Dynatel
Cable and Fault Locator The Dynatel 573 Cable and Fault Locator is a portable, battery-operated tone set that locates the path of buried or underground (UG) cables. Applications: locating butt slices; slack loops...
$835 USDFarmingdale, NJFluke CIQ-100
- Manufacturer: Fluke
- Model: CIQ100
CableIQ finds common cable faults and data rate. Cables often fail in harsh industrial environments where cables are exposed to vibration, extreme flexing, moisture, expansion and contraction from temperature cha...
Farmingdale, NJQuadTech HV5 Electrical Safety Tester
- Manufacturer: QuadTech
- Model: HV5
Good condition QuadTech HV5 Electrical Safety Testers. Located in USA and other countries. Click request price for more information.
USA