Used tester in Gauteng, South Africa

SecuriTEST IP CCTV Tester

SecuriTEST IP CCTV tester is an installation and troubleshooting tester for digital/IP, HD coax and analogue CCTV camera systems. With a single tester that can power, configure and document, SecuriTEST IP increas...

NaviTEK IE – Profinet Tester

The NaviTEK IE is a tester for commissioning, preventative maintenance and troubleshooting of PROFINET Industrial Ethernet networks as well as standard Ethernet IP networks. Designed to simplify the process, the ...

SignalTEK NT – Transmission Tester

SignalTEK NT If you install, maintain or troubleshoot data cabling and Ethernet networks, SignalTEK NT allows you to prove the performance up to Gigabit Ethernet transmission rates. SignalTEK NT If you install, m...

Chauvin Arnoux C.A 6543, Insulation & Continuity Tester, 1000V, 4TΩ, CAT III 600V

• Manufacturer: Chauvin Arnoux

The C.A 6543 is a 50V to 1kV high-performance insulation tester. It supports extreme site conditions and is an expert tool for qualitative insulation analysis:

Chauvin Arnoux C.A 6525, Insulation & Continuity Tester, 1000V, 2000MΩ, CAT III 600 V

• Manufacturer: Chauvin Arnoux

Insulation: up to 2GΩ at 250V, 500V and 1,000V DC Voltage indication before insulation measurement: 0 to 600V AC/DC (blocking if U>25V) Continuity: -20Ω to 20Ω (audible beep and compensation of leads) Resistance:...

CableMaster 210 – The Cable Tester that Fits in Your Pocket

Chauvin Arnoux CA6417 Clamp-on Ground Resistance Tester

• Manufacturer: Chauvin Arnoux

Chauvin Arnoux C.A 6526, Insulation & Continuity Tester, 1000V, 200GΩ, CAT IV

• Manufacturer: Chauvin Arnoux

NaviTEK NT PRO – R151006

Features Includes everything in the NaviTEK NT Plus as well as the following: • Fiber optic cable interface • Logon using the 802.1x protocol • Optical interface with power indication NaviTEK NT The new NaviTEK N...

NaviTEK NT – R153001

• Advanced wiremap for miswires, split pairs, opens and shorts • Distance to opens and shorts (TDR) • PoE/PoE detection • Tone generator for cable tracing • Ping and Traceroute testing • Hub blink for port identi...

NaviTEK NT Series – Troubleshooter

NaviTEK NT The new NaviTEK NT is a network cable tester for troubleshooting and maintenance of active and passive copper and fibre networks. Incorporating an improved graphical interface NaviTEK NT allows network...

VDV II PLUS – R158002

All the features of the VDV II including: • Larger 2.9″ Display • Backlight • Hub Blink • Cable Length • Distance to Open • Carry Case & Cables 1 x VDV II Plus, 1 x dual port remote unit, 1 x coax remote unit, 1 ...

Linkmaster

The LinkMaster™ cable tester consists of two units. The main unit is connected to one end of the cable to be tested and the remote unit is connected to the jack at the far end of the cable (wall outlet, patch pa...

VDV II Series – Cable Verifier

The VDV II Series are easy to use cable testers that check the integrity of copper cables commonly found in domestic, commercial or industrial voice, data or video installations, including telephone wiring, data ...

Tone And Probe – Cable Tracing

Identifies and traces wires within a group The Amplifier Probe is designed to identify and trace wires or cables within a group without damaging the insulation. It allows for pin point identification even in the ...