Used Materials Testing in Flanders, Belgium

C183 Vebe consistometer, EN, BS STANDARDS

• Manufacturer: Matest

Vebe consistometer

C194-01 Concrete pocket dial penetrometer

Concrete pocket dial penetrometer

S166-03 Test gauge, 30° angle

Cone test gauge, 30° angle

S E044-41N Probe 100g. for tests on gypsum+tang

Probe 100g for tests on gypsum + tang EN 196-3:2005

S165-01 KIT Cone digital penetrometer, complete

Cone digital penetrometer, digital, complete Penetrometer standaard digitaal bestaat uit: - Aluminium base with leveling screws and spirit level. - Chromed vertical rod with "micrometric vertical displacement dev...

Installation and training on site by producer

Installation and training on site for èe Four Point Bending Beam Testing System

A081-01 : Lightweight aggregates crushing resistance

Lightweight aggregates crushing resistance Standard : EN 13055-1 METHOD 1 Apparatus for the determination of the crushing resistance of lightweight aggregates having diameter from 4 to 22 mm, and a volumic mass o...

Calibration Load Measuring up to 3000kN

Calibration Load Indicating Device up to 3000 kN The calibration/testing services offered in this quotation are performed by European Lab Services site Sint-Niklaas. European Lab Services is accredited according ...

B024 : Permeameter

Permeameter Mainly used in situ to perform and to check the permeability and drainage on road carpets, concrete pavements, tamped earth etc. The test consists in filling the cylinder with water, after ermetically...

Calibration ISO 17025 Load Measuring up to 200 kN

Calibration under ISO17025 accreditation of a Load Ring up to 200kN. Certificat by a accredited laboratory after payment. The calibration/testing services offered in this quotation are performed by European Lab S...

Calibration Proctor Mould Small diam 100

• Manufacturer: Proctor

Calibration of a Proctor Mould: diameter and height The calibration/testing services offered in this quotation are performed by European Lab Services site Sint-Niklaas. European Lab Services is accredited accordi...

Calibration Rebound Hammer

Inspection with calibration of a Rebound Hammer Certificate is available after paiment of invoice The device must reach your Sint-Niklaas offices through your services. We can arrange for transport after calibrat...

Calibration Pull off Tester

Calibration for a Pull off tester with one channel under ISO17025 accreditation 327-CAL The calibration/testing services offered in this quotation are performed by European Lab Services site Sint-Niklaas. Europea...

S234-KIT Sand density cone apparatus 6,5"

Sand density cone apparatus 6,5" Used to determine the in-situ density of fine graned compacted soil. The test consists in digging a hole into the ground and then collect, dry and weight the sampled soil. The hol...

B056-02-KIT Automatic digital bitumen penetrometer

Automatic digital bitumen penetrometer